Roman Amphorae: a digital resource

University of Southampton, 2005 (updated 2014)

Data copyright © University of Southampton unless otherwise stated


Arts and Humanities Research Council (AHRC) logo

Primary contact

Dr David Williams
Dept of Archaeology
University of Southampton
Avenue Campus
Highfield
Southampton
SO17 1BJ
England
Tel: 080 593032

Send e-mail enquiry

Resource identifiers

Digital Object Identifiers

Digital Object Identifiers (DOIs) are persistent identifiers which can be used to consistently and accurately reference digital objects and/or content. The DOIs provide a way for the ADS resources to be cited in a similar fashion to traditional scholarly materials. More information on DOIs at the ADS can be found on our help page.

Citing this DOI

The updated Crossref DOI Display guidelines recommend that DOIs should be displayed in the following format:

https://doi.org/10.5284/1028192
Sample Citation for this DOI

University of Southampton (2014) Roman Amphorae: a digital resource [data-set]. York: Archaeology Data Service [distributor] https://doi.org/10.5284/1028192

University of Southampton logo

Schörgendorfer 558 fabric

Fabric Visual Characteristics

The outer surface of the amphora is in most cases creamy-buff (5YR 7/4), but sometimes varies between reddish-yellow (5YR 7/6) and buff (7.5YR 7/4 – 10YR 8/4). The clay is fine, hard and well fired. Small quartz grains and muscovite mica can be seen in the fabric.

Fabric Petrological Characteristics

Petrographically there are three different groups among the Vindobona amphorae: Group “Aa” is probably a version of group “Ab”. However, it may have been fired at a higher temperature than group “Ab”. The frequency of inclusions are moderate (9%). The average size of the inclusions is 0.2 mm – and none of them exceeds 0.4 mm. In group “B” the largest grains are 0.9 mm. The proportions of the individual components are similar (7%). There is a slight difference among the heavy minerals. In the group “Ac” the frequency of the inclusions are common (12%). The average size of the inclusions is 0.4 mm, the maximum 2.3 mm. The different grain sizes make this group distinct from the other two. On the basis of the geological data, the production site should be located in northern Italy: Padua or the region of Lake Garda are likely candidates. Roman Sauer

Amphora made from this fabric

 

i Schörgendorfer 558